Configuration

The following data are configurable
on each VSA 2050 through the VSA-RC remote control:


  • Select the proper beaming and tilting configuration
  • Delay in metre
  • Voice/music optimization filters
  • Phase shift
  • Mute
  • Volume
  • Stand-By


The I/R receiving diode is recessed and its directivity coverage has been narrowed to receive I/R commands just from the dedicated remote located in front of the column axis.
Thanks to this, in case two columns are one close to the other, there is no risk to drive two receivers at the same time.

Shaping the acoustic beam in a few steps

Through the remote control’s user friendly touch screen interface it is possible to select among three different groups of presets that offer a remarkable easiness in the VSA 2050 configuration process.
For two out of three groups of presets the only parameters that the operator has to insert, in fact, are the installation height of the column and the area to cover.

 
EASY FOCUS
With this series of configurations it is possible to obtain a uniform dispersion in the area between the column and a desired focus point, minimizing the amount of sound after it. By reducing the reflections outside the audience area, the Easy Focus mode is very useful in highly reverberant rooms.

 
EASY BEAM
Allow to easily select the area that the column has to cover, combining different tilt and beam angles to several installation heights.

 
FREE BEAM
These configurations allow to freely select tilt and beam angles from the presets, in order to make a custom set up.