For some reason M 18 isn’t connected with the MixRemote App. Perhaps you’ve selected the wrong Wi-Fi device from the Configuration Menu of your tablet. Select the M18-XXXXXX device among the available Wi-Fi networks, and then launch the MixRemote App again.

Approximately 25 to 40 meters, depending on direct line of sight and the environmental radio frequency pollution.

All the six AUXes of the M 18 are set as PRE faders by default. AUXes 5 and 6 can be set independently as POST faders pressing the dedicated button.

PRE-fader levels are shown on each channel’s input meter, after being adjusted by the RCF pre-amp Gain. The Trim control affects the VU meter readout only on older versions of the MixRemote App (earlier than 1.1).

User Snapshots, Shows and MultiFX Patches can be saved to internal memory.

No, but the M 18 provides a wide range of effects that can be inserted into up to four dedicated channels. It is possible to build chains of 3 or 5 different effects freely. All effects chains can be managed from the “MultiFX” page, including delay, chorus, flanger, pitch shifter, distortion effects and a wide range of additional professional Guitar Amp Emulations.

The user can change the name of all channels and AUXes. Double click on the name label and write the channel name. Names with up to 12 characters will be shown.

Valve Warmer, Xciter, Maximizer, 31-bands 1/3 Octave Graphic EQ are on hand on Main Out. A useful Standard 4-band parametric EQ is present on each AUX OUT.

Yes, the mic pre settings are digitally controlled. They can be stored and recalled into a Show memory.

Yes, through the USB memory stick and the dedicated update/upgrade app.

+21 dBu (8,69V rms)

No, but the M 18 provides a wide range of effects that can be inserted into up to four dedicated channels. It is possible to build chains of 3 or 5 different effects freely. All effects chains can be managed from the “MultiFX” page, including delay, chorus, flanger, pitch shifter, distortion effects and a wide range of additional professional Guitar Amp Emulations.

The M 18 provides up to 19 contemporary effects. Three of them are “SEND Effects” fed by dedicated FX sends. Other 16 effects can build up to 4 effects’ chains to be inserted on dedicated channels.

24 bit AD/DA I/O converters, 32 bit Floating Point internal processing, 48 kHz.

In-ear monitors can be connected to the headphones’ outputs of the M 18. The outputs are capable of driving most in-ear monitors (IEM) directly. From the SETTINGS>GLOBAL menu, set the Phones mode to “Personal Mix” and enjoy the independent Personal Mix stereo AUX send that is available in the PHONES menu.

Yes, it is. The M 18 is operating at the same level as a high-performance laptop computer, but in a more compact size, therefore the internal components get warm during normal use. You should not be concerned if you feel the heat from the side panels, because all internal components have been chosen to operate normally under these conditions. We recommend that you leave some free space around the side vent to allow heat dissipation.

You can select either a MOMENTARY or LATCHING type of footswitch. Latching footswitches are commonly available for control of analog guitar amplifiers. Momentary footswitches must be normally open (N.O.); suitable dual momentary footswitches are the Boss FS-6 and Boss FS-7, the Singular Sound Beatbuddy Footswitch, and others.